STORMDAVE
05-11-2007, 03:51 AM
Product:
EDIUS
Feature:
Support Undo in Multicam mode to un-do cut points.
Description:
When in Multicam mode, allow undo to "step backward" through cuts.
Original description:
When you finish up a Multicam session after playback and cutting...and then stop, you get the cutlist. But there is no way to undo single cuts...this should be included in v5 of Edius for sure.
EDIUS
Feature:
Support Undo in Multicam mode to un-do cut points.
Description:
When in Multicam mode, allow undo to "step backward" through cuts.
Original description:
When you finish up a Multicam session after playback and cutting...and then stop, you get the cutlist. But there is no way to undo single cuts...this should be included in v5 of Edius for sure.